 |
| |||||
| ||||||||||
2-way crossover for B&C DE254TN with 2 x 15" Mid-Bass Woofer
Custom crossover design, for a 2 x 15" full range cabinet. 2 x B&C 15NDL76 (4 ohm) wired in series) with a single B&C DE254 on a Faital Pro LTH142.
Low Pass:12dB/octave - 8 ohm @ 1.5 kHz
High Pass: 12dB/octave - 8 ohm @ 5kHz
The filter frequencies on the low pass and high pass are offset to compensate for the difference in sensitivity between the woofer and tweeter. The DE254TN is approximately 12-15 dB louder than a typical 15" woofer in the 2kHz-5kHz region, shifting the crossover point to the top of the region compensates for the difference in sensitivity and rebalances the overall tone.
The frequency response image shows the approximate response @ 1W/1m but measurements were taken without calibration in a standard room (not anechoic chamber) - accuracy to within /-3dB is assumed.
HF should be connected in normal polarity (Red to and Black to -) this helps ensure smoother phase response over the transition from LF to HF.
Low Pass:12dB/octave - 8 ohm @ 1.5 kHz
High Pass: 12dB/octave - 8 ohm @ 5kHz
The filter frequencies on the low pass and high pass are offset to compensate for the difference in sensitivity between the woofer and tweeter. The DE254TN is approximately 12-15 dB louder than a typical 15" woofer in the 2kHz-5kHz region, shifting the crossover point to the top of the region compensates for the difference in sensitivity and rebalances the overall tone.
The frequency response image shows the approximate response @ 1W/1m but measurements were taken without calibration in a standard room (not anechoic chamber) - accuracy to within /-3dB is assumed.
HF should be connected in normal polarity (Red to and Black to -) this helps ensure smoother phase response over the transition from LF to HF.
Detailed specifications unavailable, please EMAIL the sales office for additional information.
| Other Convair Electronics products similar to 2-way crossover for B&C DE254TN with 2 x 15" Mid-Bass Woofer : |
|
|
|